Відео

Code PO 848

do we have the align the pulley's?

But... they're like $10 each. Why would you do this???

You're the best! ❤ Thank you so much!!

Good job 👍Very informative and helpful!

Thank you very much for sharing this video, this was a life saver for me

Hermano gracias por tu video me es de mucha ayuda…tengo una pregunta espero puedas darme tú opinión…mi carro cascabelea al acelerarle y me dijeron que en donde está la bomba del aceite lleva una parte que se quiebra y eso lo hace cascabelear…has tenido alguna experiencia con este problema del cascabeleo?…si puedes darme tu opinión te lo agradecería mucho

That's a really good tip about taking the battery out of the angle grinder to make it safe!

This is a great idea !! Thank you so much brother !

hoigame travajo de un dia pero hay que aserlo Dios te Guarde grasias por esta ecenansa

Hola Senior, have u seen or experience an 2006 Sienna with rack and pinion bushing broken/worned that cause VSC alarm to come on and the ABS system applying the brakes. I have to remove the ABS relay to disable the ABS system from braking but i would like to fix the issue but not sure if the rack and pinion is the main caused. Thank you in advance!

Thanks for these videos!

I don't see the link to part 2

Thanks for the pointer on replacing the transmission fluid 3x's to avoid transmission slippage.

hey great video. I was wondering. if that piece that is broken in your car can just be replaced. my shifter is broke almost the same way and it just needs that piece. can I just change that

Does this apply for the 2017 sienna with the 2GR-FKS also? And what brand of pump do you use since toyota oem pumps are obviously not cutting it?

What yr Sienna is this?? I have a 2013

I am getting a crank no start on 98 dodge ram 1500 with 5.2. I am not getting the spark at the coil. Can you tell me if when you were cranking ...didthe tach needle moves? Im pretty sure I have a bad crank position sensor, but cant be sure. If Im reading right, the tach needle should move when cracking if crank position sensor works. Can you confirm that please? Also, i removed the connector on the bottom of the coil to check it for voltage. It was there, but now....when I try to push it back on, that connector wont lock. Not sure why though.

Super video. ths

نایس

Hi, I have a 2006 Toyota van , I felt the steering wheel is shaking a bit when accelerating above 50 miles , and outer edge of both tires are worn out badly , so could this is a sign of fail cv axels or something else ? Thanks in advance

Thx vato

thanks for all the detailed steps! much appreciated

Que dios te bendiga hermano

Compa tienes que darle obligatorio TORQUE a la tuerca del CV AXLE (EJE) SI no dañas El rodamiento

Hi 2001 dodge ram 1500 5.9 L 4x4 Random stall out at idle, got stranded idling in parking lot at work, thought it was fuel pump becuase would crank no start, banged on pump would start with stepping on gas , would idle perfectly fine. Driving home dies again, I repeat to see how far I go, down the block from home I start to push cuz it woundnt start, I let cool off and it starts. 1 week later I turn it on first try and start (didn’t drive it though), replaced fuel pump (I can hear it when key in ON).stayed idling for 29 minutes. Then dyed. Sometimes it start sometimes it doesn’t, oil pressure good, battery good, Ac perfect, tested all fuses( not relays) can’t find fuel pump fuse. With light tester, Took off and Tested ignition coil read fine. Took off coil connected to spark plug and was fine. Thinking bad pick up sensor that’s under distributer? Has code P0505 for IAC but I replaced it a year ago and it’s still had code but never stalled until now. Could it be bad PCM?

Is that a Metric or SAE 17mm wrench shape like a s? I need to buy one ..

Did you drain any fluids?

Just did my ml550 yesterday! Great instructions! Thank you!

Thank you, I just did the timing belt, water pump, and knock sensors on a 2005 Toyota sienna, I have codes for Bank One Bank 2 knock sensors. After changing the sensors, wire harness and all related parts when I started the car it was still doing a shaking and the code for the camshaft bank one sensor came up

What if the tensioner bolt 19mm is stripped. How would you try to get belt back on?

Un mecánico de los buenos

thanks, your doing a great job. and I know you listen to comments to make it better..

Thanks nice clear video awesome job keep up the great work

Will it be a problem if i just take off this shaft and become FWD ? Please advise, thank you.

Great video! My driver side is struggling to close the window in the summer and almost non working in the winter. Where did you get the regulator? Would it be difficult to change just the motor? The cost of the whole regulator and motor, used or new, is high for me. Thank you!

God bless you thank you blessed 🙌

Trailers sway,,, Vehicles and aircraft roll

What is the allen key size ?

Great detailed video!!!! Thank you

Question, i have an 03 Toyota corolla, and when we start up, we can hear a gurgling or rubbing sound or like the timing chain is rubbing. I cant quite explain the sound. It only does it at idle when in gear and low RPM. Im wondering if its an issue with the timing chain tensioner. Could that cause the symptom im trying to describe? After watching this, not sure its something Id try to tackle myself. What would an estimate be (rough guess) to have that taken care of? IF its not the timing chain or tensioner, what else do you think it could be?

Outstanding camera work sir! Great job! Thanks for doing this. It helped a lot!

Appreciate the video. Although ibam wondering why the coolant is green, with toyota its usually pink. Just wondering.

By the way , excellent job!

Average cost for this repair?

Hi. I find your video really helpful. What is that part where there’s an X on top of the left side crankshaft. Is it possible to have a leak from that location?

GREAT video man, you did a really good job explaining the process. I really appreciate the video, and the torque specs at the end were VERY helpful. Thanks for sharing

You are the best man, thanks for sharing this amazing video.

Thank you so much for these two videos! Other videos and my manual just said disconnect the middle steering gear but to remove it was not explained or shown. Thank you for showing us!

Thank you so much for these two videos! Other videos and my manual just said disconnect the middle steering gear but to remove it was not explained or shown. Thank you for showing us!